getting all the trimix out of vial

Sticking a needle Where? Courage, guidance and help.
rode2nowhere
Posts: 84
Joined: Wed Dec 19, 2012 9:13 am

getting all the trimix out of vial

Postby rode2nowhere » Fri Jan 19, 2018 7:55 am

How do you get all the trimix out of a vial when it gets really low, ???

FreddyFree
Posts: 150
Joined: Mon Nov 06, 2017 12:43 pm

Re: getting all the trimix out of vial

Postby FreddyFree » Fri Jan 19, 2018 8:37 am

Withdraw the needle a bit. You will never get all of it, but most.
Using Trimix injections. Not too successful looking into an implant.
Kingston, Ontario, Canada

old but young
Posts: 7
Joined: Sun Dec 31, 2017 2:06 pm
Location: Alabama

Re: getting all the trimix out of vial

Postby old but young » Fri Jan 19, 2018 10:48 am

Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.
Testosterone, pump, rings, tadalafil 10 - 15 yrs, Trimix newbie :P

rode2nowhere
Posts: 84
Joined: Wed Dec 19, 2012 9:13 am

Re: getting all the trimix out of vial

Postby rode2nowhere » Fri Jan 19, 2018 11:05 am

thanks

FreddyFree
Posts: 150
Joined: Mon Nov 06, 2017 12:43 pm

Re: getting all the trimix out of vial

Postby FreddyFree » Fri Jan 19, 2018 11:36 am

old but young wrote:Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.


Thanks oxymoron. ;)

Interesting, I may try this. However it will only save a few cents. I think the pliers need to be sterilized as well.
Using Trimix injections. Not too successful looking into an implant.
Kingston, Ontario, Canada

grandhaven
Posts: 33
Joined: Tue Aug 01, 2017 11:02 pm

Re: getting all the trimix out of vial

Postby grandhaven » Fri Jan 19, 2018 1:11 pm

I was wondering the same thing. I did ask the pharmacist and he pretty much said what you said, to pry it off carefully, but make sure you have a sterile environment and don't break the glass vial!

It's a one-time thing, as the vial will not be used again. I'm going to try it next time, as I may not have a full injection amount in the last vial. I have my refills, so it could get tricky. It's still fairly expensive as I use 60 units (0.6 ml).
ED started in late 30s with vasectomy, but doctors swear that wouldn't do it. Used Viagra, Levitra with mixed results. Started with bimix; now injecting trimix at age 59.

bldoink
Posts: 670
Joined: Mon Apr 03, 2017 12:58 am
Location: Fl.

Re: getting all the trimix out of vial

Postby bldoink » Fri Jan 19, 2018 3:28 pm

My heritage is mostly Scottish and my coin pure squeaks loudly from lack of use but even I'm not going to be prying off the rim to get the last partial drop of meds.
R.R.P 2011 Mayo Jacksonville by Dr. Michael Wehle. Nerve sparing but damaged. V.E.D, Viagra and Alprostadil manually injected. Originally Edex20. Switched to Alprostadil from compounding pharmacy - cost. Injecting 5-6 yrs. It works. Treasure coast of FL.

Tsanchez12369
Posts: 57
Joined: Fri Dec 23, 2016 7:52 pm
Location: SAN Francisco

Re: getting all the trimix out of vial

Postby Tsanchez12369 » Fri Jan 19, 2018 8:12 pm

I get everything out by adding air and then slowly withdrawing needle while filling the needle.
9 months Peyroines due to tri-mix for long standing ED. Undergoing xiaflex injections w Dr Lue in SF, traction and VED. Hope in 6-12 months injections will reduce 65 degree curvature and regain my lost length and girth in preparation for implant.

Cigar56
Posts: 486
Joined: Fri Aug 15, 2014 10:56 am

Re: getting all the trimix out of vial

Postby Cigar56 » Sat Jan 20, 2018 9:51 am

Hahaha, no offense. Some of these posts remind me of my sister-in-law, who splits open the "empty" tube of toothpaste to get another couple brushes. She is notoriously frugal, so much so that when dining out she and her husband will order just one meal and split it.

On the other hand, they are retired school teachers, and probably have $2 million in savings and assets because of their frugality and a lifetime of successful investing off of school teacher salaries.

So, I salute you guys draining those trimix bottles to the last drop!
Age 61 as of 2017. Under "active surveillance" for small amounts of cancer in prostate as of 2016. Quit using ED pills and now using injections. Considering an implant. Surgeon advises shrinking prostate to avoid damaging bladder during RALP.

User avatar
Larry10625
Posts: 2629
Joined: Sat Apr 15, 2017 10:56 am
Location: Ontario, CANADA

Re: getting all the trimix out of vial

Postby Larry10625 » Sat Jan 20, 2018 10:59 am

old but young wrote:Not to be considered as a recommendation, but just the way I did it.
1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol.
2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.)
3. Lift the seal and draw solution from the bottom.



Yup, that'll do it :D

Larry
51 years old, married 29 years. Implanted Mar 30/17 by Dr. Brock of London, Ont, CANADA. (AMS 700 CX 18 + 2). Had implant removed Apr 29/17 due to Septic Shock. Liposuction By Dr. Gan and re-implant by Dr. Brock (AMS LGX 15 + 2) Dec 14/17.


Return to “Injections”

Who is online

Users browsing this forum: No registered users and 4 guests