AMS 700 CX NOT Working

[Drake1]

I have an AMS 700 CX, MS Pump, Pre-connect, IZ [REF: 72404232, LOT: 692113001, 18 cm X 12 mm] with a AMS 700 Reservoir, IZ [REF: 72404155, LOT: 707565018, 65 ml] that were installed on August 08, 2011. The Implant seamed to function correctly until July 7, 2019. I got a hold of my surgeon, completed an Ultrasound & a determination was made that there was no fluid in my implant. My surgeon determined that it was the pump & replaced the pump & the penile cylinders [8/15/19] but did NOT replace the reservoir. I finally was able to deflate the pump on 9/25/19. However, after pumping the new pump it appears that I am getting NO fluid in the cylinders again. The pump bulb is also very hard to squeeze.
What are your thoughts about this? Any suggestions? Do you think a new Implant is needed again (3rd time?)?
Thank you again for getting back to me regarding this GREAT CONCERN of mine.

[tomas1]

Can you get another ultra-sound to see if there's fluid anywhere?

[Drake1]

I was thinking of getting another ultrasound.

[Lost Sheep]

Determining if there is fluid in the system seems prudent. If the tubing to the reservoir or the reservoir itself leaks, that would explain the non-functiong. HOWEVER, the fact that the pump bulb is hard (and is it full and round?) suggests another explanation. A stuck valve. Forcibly cycling the valve and pump bulb should reveal that. Contact the manufacturer's Patient Liaison for advice on how to do that.

[Drake1]

I have contacted AMS directly. They informed me the last time [pump prior to this one] that I could do a "hard" reset of the pump by squeezing the block of the pump opposite side of the release button and this would deflate the pump. I also attempted that with this pump & no prevail.