Deflating

[Tjholiday1977]

I am doing the cycles, but when I deflate, it does go down, but it feels like there is still a lot of fluid in the cylinders. Also, the cylinders feel really hard. I squeeze, a lot. But nothing. I’ve cycled it hard and “soft”, and it definitely hardens more than it is, but it almost feels like something is blocking full deflation. Any thoughts? Am I just wrong on it’s full deflation or have weird expectations? Any feedback is appreciated.

AMS 700 LXG implanted 10/20/2020

Thx.

[Agfa13]

Tj, I have a Titan, and although it is not the same, the principle should be. I am sure someone would be along to give you more help on the AMS.
What I do now is hold my valve down and pump the saline out, repeatedly. Dick looks like road kill, but then you fluff it out, lol

[Tjholiday1977]

Ive gotten it more deflated and now it’s weird. The upper end of the cylinders are hard while the lower parts are soft. Almost as if the tips have solidified

[tomas1]

I think the tips are solid.

[Waynetho]

Ive gotten it more deflated and now it’s weird. The upper end of the cylinders are hard while the lower parts are soft. Almost as if the tips have solidified

You may have missed my repeated comments on various threads here that it's almost like I've got two short library pencils stuffed in the head of my dick. That's the hard tips of the implant. All of them have hard plastic tips, including malleable ones.

[newbie443]

The pumps are self lubricating and are tight to begin with. And if you have a large portion of the inflatable inside when you deflate the exposed section you can just push that fluid back into the section inside you. After things break in and loosen up it can work more correctly. I had trouble with my pump working correctly for a while. Most will self correct with use and be fine. What you are looking for is to feel a faint click when you push the deflate button and then when you release the the button still feel the buzz of the fluid going back into the reservoir. If that does not happen then push the deflate button again. If you still have trouble with this try squeezing the ends of the pump block together.

[alfa88]

I have the CX. After keeping the release button pushed for 5 seconds the buzzing has pretty much ceased. I'll still be a bit chubbed up but able to tuck my prize away. If I squeeze the little guy I can feel a bit more buzz and that will empty out more but I find that the 'pop' takes a few squeezes to get going again on the next go.
The tips under the glans are hard. That's just the way it is. There are 3 tubes at the base coming from the scrotum. Again, that's just the way it is. Hope that helps.

[Tjholiday1977]

This is about an inch down, not just the tip.

[Waynetho]

This is about an inch down, not just the tip.

That's exactly right. You will eventually adjust to the fact there is a hard tip (two in fact), approximately one inch in length, in the tip of your dick, and a longer rear tip that you may be able to feel near the base of your dick that goes into your body. Between the two plastic tips is the expansion area. I learned early on that it's a bad idea to squeeze near either the distal (front) or proximal (rear) hard tip because it can cause soreness in that area. Try to focus on the silicone expansion part of your cylinder when squeezing out the saline and avoid squeezing the hard parts.

AMS LGX 700 (tips).png (149 KiB) Viewed 1087 times

[Joe Behot]

I saw my Uro this week as I have been having some issues inflating and deflating. He was able to deflate and saaid some people get the click and some don't. I don't get the click but I do get the buzz. Then he went on to inflate and got the pop first. Since then I have cycled a few times. I can deflate pretty well. Get the buzz and squeeze the rest out. However, when I go to inflate, I dont get the POP, but I do get hard. I feel like it is hard enough to penetrate, but I dont think its like a hammer. Does anyone else get hard by just pumping and not get the pop?