Page 1 of 1

WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 8:53 am
by GOLD HORSE
Hi guys, today we went full power without any concern.
The section lasted almost one hour she get her about four times I got zero.
The pain was about 5%.I notice that after a while I lost a little pressure, because I was able to pump one more time.
Wife is concern because she says if I am not fully healed, when I get 100ill % I will kill her.

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 9:22 am
by LeRoastBeef
I don't understand the question.

I hope you're okay.

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 9:59 am
by GOLD HORSE
The question is, if when you first pump let say at 90%,does the implant should keep the same pressure at all time?
I started to 100% but after a while and different positions , I noticed is was about 90% the I was able to pump one more time.

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 11:31 am
by stephen54
GOLD HORSE wrote:The question is, if when you first pump let say at 90%,does the implant should keep the same pressure at all time?
I started to 100% but after a while and different positions , I noticed is was about 90% the I was able to pump one more time.


I am already noticing (I'm almost at 13 weeks) that, depending on situations, I can pump to max, and the pump stops and will not inflate any more, and I am hard as steel. Then, yes, sometimes I notice I can add another half pump or maybe 2 small little pumps later (after having sex for a longer period of time). I still feel max 100% inflated and rock hard but somehow it will take a little more.

I asked my doc about this last week and he said you will often continue to see this incremental behavior with the cylinders over time and usage. Yes - when I pump up now...whatever level I pump to...75%, 100%, whatever...I stay at that level, I do not slide backward without hitting the deflate valve; in other words, fluid is definitely not transferring backward into the reservoir. But I think the cylinders flex and crinkle and soften over time etc...and over time they can take on a bit more additional fluid. Which is encouraging, because this supports the thinking that as penile tissues stretch with cycling and use, there is the space and capacity for additional fluid to flow in and further, slightly, expand things.

This is my basic understanding. Someone will correct where I may be misinformed though...?

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 12:47 pm
by GOLD HORSE
Thanks.

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 2:01 pm
by Waynetho
Stephen54 beat me to the answer this time. Even if I'm simply cycling, I get to max and hold it a while and a few minutes later I can get another partial pump or two. I can usually verify the pumps are real because the valve will squeal slightly and I get pain behind the tip of my glans from the cylinder tips stretching things out more.

Even Dr. Perito says in one of his videos regarding cycling, pump to max, then bend up, down, left, right and pump some more. That lends credence to the fact that the various stresses applied to the penile tissues while under inflation can cause further relaxing which in turn allows for more fluid capacity. The same holds true when I modeled/re-modeled a couple of bends I have had... With the UP-TURN bend at a third of the way down the shaft, I was able to gain 0.25 to 0.5" by simply pumping up to 80-90% and bending down on the up-turn and holding it for 5-6 minutes each time. The bend was less or even gone and my length increased. Also I started noticing a left-turn occurring so I did the same only bending against the left cylinder (forcing the front tips to the right) and I gained yet another bit of length. All in all, just bending my curves to straighten them out, has netted about a full inch over my one-month pre-op VED measurement of 5.0". I now have close to if not exactly 6.0" length (~15 cm) even though my doctor said I probably wouldn't see any gains over my pre-op length.

Back to the point: Each time I modeled or bent curves back to straight, I was able to get at least another partial pump afterward.

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 7:58 pm
by Lost Sheep
GOLD HORSE wrote:Hi guys, today we went full power without any concern.
The section lasted almost one hour she get her about four times I got zero.
The pain was about 5%.I notice that after a while I lost a little pressure, because I was able to pump one more time.
Wife is concern because she says if I am not fully healed, when I get 100ill % I will kill her.

But what a way to go, eh?

Re: WIFE IS VERY CONCER

Posted: Sat Feb 15, 2020 10:32 pm
by Agfa13
Of course she will be concerned. Once you get started, she does not want to stop!!! So take things slow, you know things are working, but you got away with no hurting this time. Don't push your luck, your wife will be pissed because you could have avoided the hurt if you just took it easy, lol
There is the thing we males have, its called Testosterone, ever heard of it? It gets us guys in trouble with friends, family, even loved ones, lol.