FrankTalk.org

At first I thought that uneven measurements were rare. Now I know that they are fairly common. Perhaps one in two implants are off by one or two mm. A crooked glans is the most common sign. As the cylinder ends erode your body, thinning and stretching the tissue your penis quickly tries to adapt.
Severe mismeasurement is less common. So far only four brothers have posted with the tell tell signs of a twisted glans. Uneven tip pressure can cause distal crossover. Others have mentioned having a permanently cocked head or bowed shaft problems which they did not have prior to surgery. 1 Brothers condition is exactly like mine same implant same r t e s same-side mismeasurement and his right tip has penetrated his glans. That is what I'm trying to escape from.
In my opinion there is no excuse for any miss measurement but especially not for a severe one. If a surgeon does not have the skills needed to suceed with every patient he needs to change his occupation. Dog catcher comes to mind. Or Waste Management engineer.

DougAnd wrote:At first I thought that uneven measurements were rare. Now I know that they are fairly common. Perhaps one in two implants are off by one or two mm. A crooked glans is the most common sign. As the cylinder ends erode your body, thinning and stretching the tissue your penis quickly tries to adapt.
Severe mismeasurement is less common. So far only four brothers have posted with the tell tell signs of a twisted glans. Uneven tip pressure can cause distal crossover. Others have mentioned having a permanently cocked head or bowed shaft problems which they did not have prior to surgery. 1 Brothers condition is exactly like mine same implant same r t e s same-side mismeasurement and his right tip has penetrated his glans. That is what I'm trying to escape from.
In my opinion there is no excuse for any miss measurement but especially not for a severe one. If a surgeon does not have the skills needed to suceed with every patient he needs to change his occupation. Dog catcher comes to mind. Or Waste Management engineer.

You are very right !

Upon watching closely while pumping, I find that both sides do not expand equally. One time the right side will outpace the left. Next time the left will lead the race. Only about 1/8 in difference. If I bend my dick around and pump more they will finally become even.

I think that's a different problem old beak
I just fully deflated this morning lay down on my back in bed and bent to the left 90 degrees just exactly the same as right after my surgery. if I don't constantly use vacuum pressure I go right back to where I started from. Uneven measurement has only one solution. And that is Surgical if you can find a doctor who will do it.