Page 1 of 1
Walnut hard pump
Posted: Thu Oct 25, 2018 12:54 pm
by RoboCock
Sorry if this has already been addressed, I have posted my transformation earlier, but my brotherhood here are more helpful than my own damn doc. Yea my deflate block attached to side of scrotum, actually in some infection that hasn’t gone away. Third round of antibiotics so I hope it works and it will drop. Now to my question;; stayed in the tub for about an hour last night putting everything I had into squeezing my pump with nothing, thought I would have to get some vice grips. Is there a chance that the tubes are tangled which won’t allow me to pump or even “feel the pop”. Heck I can’t even tell now where by deflate button is. I’m so frustrated, regretting having this done right now. Least before I didn’t have the extreme worry other than popping a lot of pills to get semi hard. Anyways thank you all in advance!!
Re: Walnut hard pump
Posted: Thu Oct 25, 2018 1:04 pm
by ED2013
My main concern would be the infection. It may well be that the mass in your scrotum is not letting you feel the pump. When you take a hot bath and the scrotum relaxes it should be easy to feel the pump and button. You could gently try to pull the scrotum skin away from the pump. When is the last time you saw the doc? I’d see him as soon as possible to get a check up.
Re: Walnut hard pump
Posted: Thu Oct 25, 2018 3:08 pm
by LMCatman
it gets better....be patient....my first implant I was like two months to just "figure out the plumbing"....good luck!
Re: Walnut hard pump
Posted: Thu Oct 25, 2018 5:44 pm
by oldbeek
On the AMS 700lgx, several times I would have to squeeze the block on the ends. Squeeze end to end. That reset everything. call Jamie. at 303-591-8599 AMS rep. She will talk you through it. I had the same problem a few times when it was new.