Page 1 of 1

bending implant

Posted: Mon Oct 15, 2018 5:21 pm
by jelizondo12
I have a AMS 700cx implanted 6/1/15 and it has worked pretty good up until about several months ago. The problem is when entering a tight pussy or butthole it bents at the root. I tried holding this area real tight to keep it straight and it's like rubber. After using a lot of lube and prepping with my finger I can get it in and it's balls to the wall. Do any of you have this problem or know how to fix it.

Re: bending implant

Posted: Tue Oct 16, 2018 9:20 pm
by alibaba
Do you have tip extenders? Can you pump it up harder?

Re: bending implant

Posted: Fri Oct 19, 2018 9:42 pm
by DougAnd
So older than 3 years. Well the cylinders do get softer especially with AMS. Your best hope is micro pumps before to max out inflation. But yes if I'm not pumped up hard I am much more flexible. But then again I like to be softer don't have your problem.

Re: bending implant

Posted: Sat Oct 20, 2018 7:04 pm
by jelizondo12
Yes I have extenders, I pump 15 times, wait a couple of minutes and pump 15 more and some times 30 more but if I go over this amount it just by passes the pump and doesn't get any harder. My penis will get hard but when I push on the tip straight back it bents. I also noticed that after a night of love the area around my root hurts like hell probably from all the pounding lol

Re: bending implant

Posted: Mon Oct 22, 2018 1:41 pm
by Tsanchez12369
How many rear tip extenders? I here the more you have, potentially the less stable.

Re: bending implant

Posted: Tue Oct 23, 2018 3:01 pm
by jelizondo12
I have 2 tip extenders, just noticed this morning while pumping up my penis is starting to bend forward, I think it's probably the skin being shorter then the implant.

Re: bending implant

Posted: Tue Oct 23, 2018 3:26 pm
by oldbeek
I can feel where my RTEs attach to the implant. When soft feel around the pelvic floor. You should feel the RTEs. They will be hard. Now pump up hard. Feel and see if the hinge effect is right at the top the RTEs. If the hinge is at the top of the RTEs, they are broken. They are supposed to be like a tapered cup holding the base of the implant. The more pressure the implant has, the more secure the cone bases of the implant is in the cup.

Re: bending implant

Posted: Mon Nov 12, 2018 10:00 pm
by jelizondo12
Well I finally got to see my urologist and after bending my flat penis back and forth and inflating and feeling it carefully declared no problem. I showed him that even when hard I could bend it IF you push straight forward on the head and he claimed that it was normal and nothing could be done to keep it from bending. I believe it was almost impossible to bend when first implanted but its been 3 years and I guess its losing some of its toughness.

Re: bending implant

Posted: Mon Nov 12, 2018 10:38 pm
by PeterLBC
This is why i went Titan. Lot's of tight ass out there !