Page 3 of 3

Re: AMS 700 CX # pumps to max inflation

Posted: Sat Sep 29, 2018 12:25 pm
by roksolid
Tsanchez12369 wrote:So, it seems 35-40 full pumps to me for max pump.


And on the other end of the scale, 6-8 full pumps of my bulb gets me to a comfortable erection for intercourse, 2-3 pumps above that is a painful erection.

rok

Re: AMS 700 CX # pumps to max inflation

Posted: Sun Sep 30, 2018 7:07 pm
by Tsanchez12369
Strange how the same implant and size and the experience is so different. pumped to max with all those pumps and I have no discomfort or pain...

Re: AMS 700 CX # pumps to max inflation

Posted: Sun Sep 30, 2018 11:13 pm
by TomW46
Depending on how on how hard I pump it takes 35-40 for max. After 30 minutes I can get a little more with about 10 very hard pumps. But, my wife doesn't like it that hard. She's good with about 25. She says that feels more like the original to her.

Re: AMS 700 CX # pumps to max inflation

Posted: Mon Jan 13, 2020 10:50 am
by young_and_impotent
I can seem to pump infinitely. The pump isn't flat, I read that pump flat is an indication that fluid is over.

Doesn't seem right.

I am waiting between pumps, should I wait longer?

Also I think I can withstand this stretch infinitely, which is kinda sad. :(

Re: AMS 700 CX # pumps to max inflation

Posted: Mon Jan 13, 2020 6:53 pm
by Waynetho
young_and_impotent wrote:I can seem to pump infinitely. The pump isn't flat, I read that pump flat is an indication that fluid is over.

Doesn't seem right.

I am waiting between pumps, should I wait longer?

Also I think I can withstand this stretch infinitely, which is kinda sad. :(

Sounds like the valve is stuck in the middle. Reset the pump and it may work.

Squeeze the valve block above the bulb from both ends and see if the bulb completely refills. Then press deflate button, squeeze some saline out of the cylinders and then squeeze the bulb again and listen for the "POP". Try to inflate to max to make sure it fixed it.

Re: AMS 700 CX # pumps to max inflation

Posted: Fri Feb 28, 2020 7:51 pm
by Donnie1954
Due to the relief valve in the device, it is impossible to over pump your AMS. I used this discovery in my Stretching Routine found under Implants.
Pump it until it's hard enough to do the job and enjoy!

Re: AMS 700 CX # pumps to max inflation

Posted: Fri Feb 28, 2020 9:13 pm
by Waynetho
Donnie1954 wrote:Due to the relief valve in the device, it is impossible to over pump your AMS. I used this discovery in my Stretching Routine found under Implants.
Pump it until it's hard enough to do the job and enjoy!


My MS pump gets ROCK solid where it won't take any more squeezes. I can switch to my dominant hand and get a faint squeak several times (all the time my penis feels more and more like it's about to explode). The last 2-3 tiny "SQUEAKER" pumps with my dominant hand are the only ones that cause any discomfort anymore since I'm 123 days since implantation. I've pretty much maxed out my implant (15 cm penis length, 15 cm implant length, IKR, impossible, huh?)

When I get the last hard pump that does makes any squeaking and causes anymore pressure pain, the remaining attempts are like squeezing a glass marble... absolutely no give to the bulb. Apparently my relief valve is non-existent or non-functional. :roll:

Re: AMS 700 CX # pumps to max inflation

Posted: Fri Feb 28, 2020 9:26 pm
by Lost Sheep
Waynetho wrote:
Donnie1954 wrote:Due to the relief valve in the device, it is impossible to over pump your AMS. I used this discovery in my Stretching Routine found under Implants.
Pump it until it's hard enough to do the job and enjoy!


My MS pump gets ROCK solid where it won't take any more squeezes. I can switch to my dominant hand and get a faint squeak several times (all the time my penis feels more and more like it's about to explode). The last 2-3 tiny "SQUEAKER" pumps with my dominant hand are the only ones that cause any discomfort anymore since I'm 123 days since implantation. I've pretty much maxed out my implant (15 cm penis length, 15 cm implant length, IKR, impossible, huh?)

When I get the last hard pump that does makes any squeaking and causes anymore pressure pain, the remaining attempts are like squeezing a glass marble... absolutely no give to the bulb. Apparently my relief valve is non-existent or non-functional. :roll:

When I get to maximum inflation, I can still squeeze the bulb (estimate 15-30% of the volume transfer I can get with the initial pumps at zero inflation of the implant). The bulb resists being squeezed, but does indent some. I speculate that there is some give to the bulb that makes it seem as if I am transferring fluid. Or perhaps the one-way valve in the pump allows a little bit of backflow as it seats itself closed.

Anyhow, pumping deeply, I get 20 full-depth squeezes before the back pressure prevents full-depth squeezes and another 10-20 (depends on how strong my fingers are) before I get no more rigidity out of the implant.

I am completely mystified how some guys get full rigidity/size with as few as a half-dozen squeezes and others go 40 or more to get the same degree (reportedly) of rigidity. I don't disbelieve any of the reports But I remain amazed at the difference in performance. If I could get full coital stiffness with only 6 squeezes, I could go from foreplay to coitus a LOT faster! Lucky me, my girlfriend is not bothered at all by the pumping process. I suppose if I was trying truly emulate a naturally occuring spontaneous erection or trying to hide the fact that I am implanted from a sexual partner, it would be a problem.

Re: AMS 700 CX # pumps to max inflation

Posted: Sat Feb 29, 2020 8:38 am
by Donnie1954
I have been amazed too by my implant. I couldn't be more pleased and I LOVE MY DICK (old joke).