How to properly deflate Coloplast Titan OT??

[body2body]

Hey guys,

I got my Coloplast Titan OneTouch about 6 weeks ago and can start cycling now and also deflate to go out without a semi-boner.

Unfortunately I am not sure about how to deflate properly.

When I deflate I press the button or hold the button and squeeze my cock, so I can fell all liquid out and can also feel the empty cylinders. Kind of strange feeling. So then everything is fine.....but aftr about 15-20 minutes my cock feel a bit erect again and I can feel it filled up more than right after squeezing and when I look at it, it looks like filled up again. Not a hard cock, but far from "empty" also

No way to put it on one side and fit into my yeans, like before. Can only wear like jogging-trousers and even there you can kind of see my cock stick up a bit and looks like a little pervert

What is the PROPER way to deflate with Coloplast Titan and keep it empty?

Thanks a lot,
Andi

[mark1958]

deflate then add a pump or two to shut valve

[UpNorth]

Deflate to go out without a semi boner? Titan?
Never going to happen. Just embrace it.

[Jgoody]

I agree that giving it one pump after deflating may help if it's auto refilling. My surgeon told me at activation to kind of accordion squeeze it when deflating to try to get fluid that was in the proximal area of cylinders out of there because I had larger tubes. This would apply to a deep crux as well. So it could be the fluid that's still in the cylinders that's inside the body or otherwise still "trapped' in the cylinders after squeezing just the distal part of penis on deflation.

[Colby-jack__]

Ive read most guys give the pump a squeeze or 2 but I've been deflating as much as I can followed by giving my dick itself like 3 good squeeze-and-releases. I think this does the same thing with less fluid back into the cylinders.
I THINK it pushes enough fluid past the valve to close it down and prevent it from letting fluid back into the cylinders.
This all seemed like a big problem at week 3 and 4 and now at week 8 I think my cylinders have softened up so much more its less of an issue.

[El_chavo]

I still have the same problem