first time Trimix user

[1969CevyC10]

Gentlemen, I am a first time Trimix user, I have previously been taking Edex 40 in pre-loaded syringes so there
was no question about mixing or loading a syringe. In the mail came 4 small bottles of Trimix which are marked
20MCG/2MG/30MG/ML. The script I have reads 20MCG/Phent2/Papav30MG 1ML. There were no syringes sent with
these so I assumed you are suppose to use a diabetic syringe and fill the syringe to the 20 mark. I did this but there
is over half the bottle still left after loading the syringe so I am assuming I am not doing this correctly. If I look on
the old Edex syringe that 2.0 mark is much much greater than the 20 mark on the diabetic syringe so can anyone
please tell me what I am not understanding and what I am doing wrong? I would really like to try the Trimix but
when I gave myself an injection of Trimix with what I loaded in the syringe last night it wanted to work but I could tell it just was not strong enough. Please help me understand this,,,,,,,,thank you so very much Gentlemen

[bldoink]

...

[1969CevyC10]

Thank You for all your information, the vials are 1ml. The VA allows four injections/month and they sent
4 1ml bottles. My script reads "4 injections/month for ED", so I can only assume they are saying you get
4 bottles of Trimix per month and you get 4 injections, unless I am reading this wrong..... I am just wanting
to know what mark to use on what kind of syringe. Last night I used the 20 mark on an insulin syringe but it
was very ineffective and there is a lot of liquid left in the bottle, I am very confused. On a 3 ml syringe the
20 mark is much larger in liquid but the needle is also much larger so I am not sure which I should be using.
I know this is not all the difficult to figure out but there were no instructions sent with the vials.

[1969CevyC10]

If the 20 dose was not enough and there is liquid left in the bottle, could I not fill a syringe to the 40 mark to
get a more satisfactory result???