How can I be missing?

[mhorowit]

I've tried three injections so far. Two failed to give results. Based on what I'm reading, it's possible I'm "missing" the spongy area. That's not a small target! How is it possible that I'm missing? I'm injecting in the middle third, at the 9 o'clock position and at 90*. What could go wrong? - Mike

[Anonymous FT Member]

Didn't the specialist you visited instruct you or tell you what to expect?

[solvingadream]

Hi Mike, what is the strength formula of the trimix you are using? And needle length? How many units were your last trimix shot?

Neil

[mhorowit]

Neil - 5/16", 10 units , (PG/PAPA/PT)10/30/1
The order came with 1/2" needles, but the group seemed to be suggesting the smaller size - Mike

[mhorowit]

Didn't the specialist you visited instruct you or tell you what to expect?

Hello unnamed person - I had my appointment with the doctor, the meds arrived three days later. I called for an appointment with the specialist and they set me up with an appointment a month down the road. Would you have waited? - Mike

[Flounder]

Neil - 5/16", 10 units , (PG/PAPA/PT)10/30/1
The order came with 1/2" needles, but the group seemed to be suggesting the smaller size - Mike

Personally, I had a lot more misses with the 5/16” needles. I switched back to 1/2” with much better success. I’m above average girth and that may explain it. As you said, the target area is pretty large but you still need to reach it.

[bldoink]

Neil - 5/16", 10 units , (PG/PAPA/PT)10/30/1
The order came with 1/2" needles, but the group seemed to be suggesting the smaller size - Mike

Either size should work for most guys. For me it can be easier to go too deep with the 1/2" needles. However some guys will need the longer needle.

I sent you a PM.

[mhorowit]

Got it, just as I was about to ask about rings and injections! - Mike

[sogwap]

I've tried three injections so far. Two failed to give results. Based on what I'm reading, it's possible I'm "missing" the spongy area. That's not a small target! How is it possible that I'm missing? I'm injecting in the middle third, at the 9 o'clock position and at 90*. What could go wrong? - Mike

I am not a medical profession, but I am a Trimix user like you.

On my second injection I too missed, My wife didnt talk with me for two days. So yeah sucks.

You said you are shooting 9 o'clock position at 90* with 5/16 inch needles.

First observation are you injecting at 9 o'clock on the penis or corpora caverosa. If it's 9 0'clock on the entire penis might be a bit too low.
Also if using 5/16 inch needles be sure to insert fully.

I would also suggest try using 2 or 10 o'clock position.

[sogwap]

The order came with 1/2" needles, but the group seemed to be suggesting the smaller size - Mike

Either that or the larger needle is scarier to us men.

</end sarcasm>