Injection questions

Sticking a needle Where? Courage, guidance and help.
Wesbigs
Posts: 12
Joined: Tue Oct 22, 2019 12:22 pm

Injection questions

Postby Wesbigs » Sat Nov 16, 2019 2:34 pm

I got my trimix last week and have injected a total of 3 times including the trial at the doctors office. The results have been pretty good but I think I’m going to try upping the dose a bit. My prescription is pretty low dose (.6 PGE I think) and I used .2cc last night but had to use a dick ring to get it good enough for penetration.
As a recent RP survivor my doc has me taking 20mg of Cialis a couple times a week to keep the blood flowing down there. I’m assuming that if I’ve taken the Cialis within a day or two that I should reduce my trimix dose. I’m just not sure by how much I should reduce it. Anybody have any experience with this? The wife's libido isn’t great in the first place and I would like to be able to keep things spontaneous.

The other question is that the trimix kit I got mailed to me has syringes with 27g needles and I was instructed to fill the syringe with that then change the needle to a 30g to inject. I’m assuming that this is to keep the smaller needle from bending when going into the vial.
Does anybody use the 30g needles to fill the syringe? Do they bend easy?
RALP August 15, 2019

bldoink
Posts: 1932
Joined: Mon Apr 03, 2017 12:58 am
Location: Fl.

Re: Injection questions

Postby bldoink » Sat Nov 16, 2019 3:35 pm

I'm pressed for time so I'll try give a better response later. I fill and inject with the same 31g needle.
R.R.P 2011 Mayo Jacksonville, Dr. Michael Wehle. Nerve sparing - badly damaged. C in margin. V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ ~ 14 units. Originally Edex20, then compounded PGE-1 - cost. Inject. ~ 9 yrs. It works. Treasure coast of FL.

60s_surfer
Posts: 82
Joined: Mon Jul 30, 2018 1:42 pm

Re: Injection questions

Postby 60s_surfer » Mon Nov 18, 2019 8:11 pm

All lthe Trimix bottles that I have used have had a thin enough rubber top that I can fill the syringe and inject using the same needle, which is a 5/16 inch (8 mm) 31 gauge needle. I have rarely if ever bent a needle while inserting it through the rubber during the filling process. I have used Trimix since February, 2017; this means roughly 250 injections The only reason I could see to switch needles would be if, for some reason, your provider used a really thick rubber stopper.
71 years old in 2018; married 49 years. ED since 2001. PD5 inhibitors (Viagra, etc.) worked with increasing dosages until side effects got too bad by 2017. Now using Trimix injections. Delayed ejaculation has been a continuing problem since 2012.

SteveSW
Posts: 172
Joined: Sat Sep 08, 2018 6:23 pm

Re: Injection questions

Postby SteveSW » Mon Nov 18, 2019 9:20 pm

I too fill and inject with the same 31g needle. Only bent one once.
66 with 15+ years of chronic Peyronie's, venous leak and bad ED which of late, is has gotten worse. Currently injecting 60 units of 100/6/30 Trimix and it's starting to fail. Searching for implant Dr here in St. Louis

Phil65
Posts: 72
Joined: Sun Oct 28, 2018 2:25 pm

Re: Injection questions

Postby Phil65 » Tue Nov 19, 2019 4:56 pm

Wesbigs wrote:...Does anybody use the 30g needles to fill the syringe? Do they bend easy?


I use exactly that and didn't even think it could be a problem. No, never bent. :)

BD Ultrafine II - 1mL syringe - 8mm length (5/16") - 30 Gauge
Trimix 2 (30-2-20)
Papaverine 30mg/ml - Phentolamine 2mg/ml - Prostaglandin 20mcg/ml
BD Ultrafine II - 1mL syringe - 8mm length (5/16") - 30 Gauge
NOW Bimix: Papaverine 30mg/ml - Phentolamine 0.5mg/ml
Dosage to be updated once I try it.

steven1
Posts: 20
Joined: Mon Sep 10, 2018 4:34 pm

Re: Injection questions

Postby steven1 » Wed Nov 20, 2019 10:38 am

At different amounts of a Bi mix i always have 4 to 6 or more hrs erections
I lower the dose and can’t get to where I need to be

Wesbigs
Posts: 12
Joined: Tue Oct 22, 2019 12:22 pm

Re: Injection questions

Postby Wesbigs » Wed Nov 20, 2019 11:13 am

steven1 wrote:At different amounts of a Bi mix i always have 4 to 6 or more hrs erections
I lower the dose and can’t get to where I need to be


Is that with taking viagra or cialis?
RALP August 15, 2019

User avatar
flyingduck2019
Posts: 275
Joined: Tue Aug 06, 2019 3:15 pm
Location: Hemet, California

Re: Injection questions

Postby flyingduck2019 » Wed Nov 20, 2019 1:39 pm

I have used both, the 5/16 31g and the 1/2 30g needles. I have never bent a needle. I did switch from the 5/16 inch needle, even though I like it best, as I had several failures getting erections. I did some experiments and have determined that, because of excessive foreskin which I push back behind the head when injecting, the 5/16 needle does not always go deep enough to deposit the juice into the cavernous area. I have not had one failure using the 1/2 inch needle.
Phil, 73, married 52 years, ED started about 7 years ago. After viagra and cialis and pumping have found Trimix. Use 10 units injected with a partial erection. 30g-5/16" or 30g 1/2"needle. 10-1-30 :D :D :D Wife likes it too :D :D :D :D

once a writer
Posts: 238
Joined: Tue Jan 07, 2014 5:53 pm
Location: Oregon

Re: Injection questions

Postby once a writer » Wed Nov 20, 2019 8:57 pm

Does anybody use the 30g needles to fill the syringe? Do they bend easy?


Because concern about bending a needle suggests fears about breaking a needle when it's embedded in your dick . . .

Try this experiment:

Take a used syringe, grip the needle with a pair of pliers, and bend it back and forth, as you would when trying to fatigue-break a piece of wire. You'll get somewhere close to 20 reps before the needle gives up.

Knowing this cools a lot of anxiety.
Eugene, Oregon, USA. Born 1941. Married 1968. ED since mid-1990s. Began trimix January 2014. Dosage gradually increased over time. Added cock ring in 2016. After dosage reached 30 units, switched to quad mix in May 2018. On blood pressure meds.

mcdave555
Posts: 50
Joined: Wed Nov 27, 2019 4:41 pm
Location: Arizona _ Canada
Contact:

Re: Injection questions

Postby mcdave555 » Wed Dec 11, 2019 11:44 am

I an also using 5/16 length needles , I have bent a couple but think it how I am holding the vile when filling,
most times they work well and not bend at all


Return to “Injections”

Who is online

Users browsing this forum: No registered users and 6 guests