Inject ease

Sticking a needle Where? Courage, guidance and help.
Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Inject ease

Postby Robert66 » Tue May 28, 2019 4:01 am

So i buy one thinking better and more accurate then the slam it in unit. Loaded it up and feel stupid i get nervous sweaty i dont expect any pain but keep readjusting looking in mirror. Too low? To close to vien ? Second guessing pull the trigger then meet lots of resistance pushing plunger . maybe wrong spot not deep enough ? But wait drop of blood doesnt that mean right spot??0
edex and tri mix 45/1/27 26 units

User avatar
bldoink
Posts: 3686
Joined: Mon Apr 03, 2017 12:58 am
Location: Fl.

Re: Inject ease

Postby bldoink » Tue May 28, 2019 10:09 am

My personal experience has been that if you have a lot of plunger resistance you are not positioned correctly, regardless of blood drop.

This is from the Edex Full Prescribing Information sheet (insert) which includes injection instructions towards the bottom: http://www.endo.com/File%20Library/Products/Prescribing%20Information/edex_prescribing_information.html

16. Hold the injection device as shown in Figure M. Do not touch the plunger at this time. Position the needle horizontally and gently insert the needle into the selected injection site until the needle is almost completely inserted into the penis (Figure M). Now place your thumb on the plunger and inject the solution slowly over a period of 5 to 10 seconds (Figure N).

17. If the solution does not inject easily, or if you immediately experience a burning pain at the injection site, reposition the needle by advancing it slightly or by partially withdrawing it until the solution can be injected easily and painlessly.

I should note that the Edex kits come with 1/2" needles, if I recall correctly.
R.R.P 2011 Mayo Jacksonville, Dr. Michael Wehle. Nerve sparing - badly damaged. C in margin. V.E.D, Viagra and PGE-1 (80mcg/ml) injections @ ~ 14 units. Originally Edex20, then compounded PGE-1 - cost. Inject. 10+ yrs. It works. Treasure coast of FL.

Cigar56
Posts: 684
Joined: Fri Aug 15, 2014 10:56 am

Re: Inject ease

Postby Cigar56 » Sat Jun 01, 2019 12:00 pm

I own all the auto injectors but finally gave up and just went manual. Much better control that way. I switched to a shorter needle to help with the visual aspect. Then I stared using either a cooling spray (Biofreeze) or a numbing ice cube to eliminate the initial "pinch."

I apply the spray or numb with the ice cube. Then I touch the tip of the needle against the injection spot. Then I just push it in. No pain, and the best precision possible.

That's a lot coming from me because I aboslutely hate needles of all kind.

Hope this helps a little.
I've tried everything -- pills, injections pumps -- and now I am at the final frontier.

Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Re: Inject ease

Postby Robert66 » Sat Jun 01, 2019 7:20 pm

Thanks for that info
edex and tri mix 45/1/27 26 units

Hunchback
Posts: 513
Joined: Sun Apr 30, 2017 5:00 am

Re: Inject ease

Postby Hunchback » Sun Jun 02, 2019 6:16 am

Well how were the results?
39 years old, married. ED all my life because of spinal cord injury caused by a tumor in early infant age. Using standard EDEX20 since 2007. Increasingly bad results with EDEX in the last few years, but had very good results for at least 10 years.

Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Re: Inject ease

Postby Robert66 » Sun Jun 02, 2019 6:28 am

Went in smooth and used a small amount of bio freeze still adjusting dose using a standard mix uo to 16 units about 60%for one hour next 20 % my mix is 17. 17. .58
edex and tri mix 45/1/27 26 units


Return to “Injections”

Who is online

Users browsing this forum: owasso and 19 guests