Page 3 of 5

Re: First Time Jitters

Posted: Mon Dec 03, 2018 6:40 pm
by tomas1
I'm curious to see if the strong formula was prescribed by an actual doctor?
I find it hard to believe and obviously stupid if so.

Re: First Time Jitters

Posted: Mon Dec 03, 2018 7:57 pm
by Bob1974
Anon-E-Mouse wrote:I'm a little concerned over comments saying the strength is strong. This is my very first prescription and first time injecting anything so curious to learn a bit more. I see people talking about taking 20-100 units, yet at 9 units I thought my dick was about to fall off


There are many different strengths of Trimix. My script is for 40/30/1 and 6 units is what I inject if I'm anticipate extra play time but sex for me is also possible with 50mg of Viagra. My pharmacy has a form for my urologist to fill out for Trimix prescriptions and 80/30/2 is the strongest mix on there.

Re: First Time Jitters

Posted: Mon Dec 03, 2018 8:20 pm
by Anon-E-Mouse
tomas1 wrote:I'm curious to see if the strong formula was prescribed by an actual doctor?
I find it hard to believe and obviously stupid if so.


I went through Defy Medical to get my Tri-Mix. I had to do blood work, get a physical and do a phone consult with a PA for an hour before they prescribed the meds.

https://www.defymedical.com/services/na ... ss-program
https://www.defymedical.com/12-services ... injections

Tbh I'm a bit concerned now hearing others saying this is an insanely strong mix. Im guessing on my next refill I should ask for a lower strength? I also know the importance of not taking more than 0.05ml anymore and that 0.09 was too much.

Re: First Time Jitters

Posted: Mon Dec 03, 2018 8:43 pm
by tomas1
That sounds like a good plan. I no longer respond to pretty strong quad-mix formulas but never got up to the strength you used.
I think you will find the less strong formula more painless also.
Something like 30/?/? is what I used after my first way too weak formula.
Good luck.

Re: First Time Jitters

Posted: Sat Dec 08, 2018 2:14 am
by Anon-E-Mouse
So I've been having some pretty odd results and curious what others thing.


1st Attempt - 5 units, worked for a good 20min when I was "done" then deflated.

2nd Attempt - 9 units, worked for about 4hrs even though I took Sudafed 120mg at 2hr mark.

3rd Attempt - 4 units, No erection. Did another 2 units after waiting 30min, still nothing.

4th Attempt - 8 units, nothing!

Im using the Autoject with a 30G 1/2 needle and the depth set on C. My lady does all the injecting because I shake too bad.

I'm afraid to try say 13 units for the 5th try but Im tired of suddenly having no effect despite the strong dose.

Any ideas?

Re: First Time Jitters

Posted: Sat Dec 08, 2018 11:39 am
by Bob1974
Based on your 1st and 2nd Trimix experiences it sounds to me like you're 3rd and 4th attempts you didn't get the medicine into where it needs to be and missed the mark. I know that its frustrating when this happens and it happened to me once before when I first started injecting trimix. Needle placement is IMPORTANT or Trimix doesn't work... upping the amount could be very bad when you finally hit the mark where the medicine will be effective. Based on what you said about your 1st and 2nd experiences, if it were me I would see what 6 units would do. If 5 units gave you 20 minutes then perhaps 6 units which is 20% more injected into the right spot might give you 30 minutes and seems like a conservative approach? Shake your vial before inserting the syringe to draw out your dose. Do as much research as you can on how to inject Trimix till you feel confident about it. I don't know much about auto injectors and I just use a 31 guage 5/16" long syringe. I personally usually grab the head of my dick and stretch out my flaccid dick and slowly put the needle easily into the skin of my dick at either 3 or 9 O'clock trying to miss veins on the left and right side of my dick alternating sides with each dose, then the needle feels like its hitting another layer after it's in to the skin and this layer is a little tougher and harder to poke through. Once the needle is through this tougher 2nd layer I bury the 5/16" long needle all the way in and then push the plunger down putting the boner juice where it needs to be. I don't rush these steps. Don't just go by what I do, RESEARCH RESEARCH RESEARCH! Find some how to videos, websites and forum posts that describe these steps in detail. My urologist showed me with my first dose how to weave my dick under my pointer finger over my middle finger and under my ring finger to stretch my flaccid dick out to inject the needle in. I've tried this technique a few times but personally like the first way I described stretching it out by grabbing the head.

Re: First Time Jitters

Posted: Sat Dec 08, 2018 1:32 pm
by bldoink
Bob's response was good.

I might suggest you have your Lady watch the video I gave you the link to and then let her try the manual method. With the autoject you get no feedback to tell you if you're in the sweet spot. I'd save the autoject until you get more experienced on angle and depth.

I think you're playing with fire jumping all over the place with your dose. Of course you doubled your dose on your 2nd injection when I strongly suggested you not do that, so whatever.

Also with such a potent dose it might (my guess) be better to inject the juice very slowly to reduce the shock effect. My mono-mix is also very potent and I also inject very slowly, in pulses, for that reason.

Good luck

Re: First Time Jitters

Posted: Sun Dec 09, 2018 12:59 am
by oldbeek
Yes , very hi formula. Mine was 12.5/30/1,,, 5 units did the job. On injection, I would use 5/16 31 ga. I had good success by VAC first to get plump. My tunica was very tough causing the auto inject to bounce off and bend the tip. Total failure. I would inject with a little jab. That would get it to hit the tunica. Then I would jab again. That would get through the tunica. Then slowly press the plunger. Press the plunger hard after all is injected. when you release that hard pressure, the plunger will draw a small amount of blood back into the needle. Have a white tissue ready when you pull out the needle and press the plunger again over the white tissue. You will see a drop of red to tell you that you injected into the right spot. You have to devise a procedure to examine and see that blood to know if it is a dose problem or an injection problem. never had a failure when I saw the blood.

Re: First Time Jitters

Posted: Sun Dec 09, 2018 8:03 pm
by Anon-E-Mouse
I really appreciate the feedback from everyone. I went back and watched a guide on calibrating the AutoJect and one thing I noticed is that my needle (1/2") didn't go all the way out and that I had the screw in the adjustment guide all the way in so that 99% of the needle came out and it stopped just before the plastic part.

Knowing that 5 units lasted 20min and 9 units lasted 4hrs I went with 6 units and with the AutoJect set to insert much deeper, I hit my target and had probably a 40min duration.

Thank God I wasn't stupid and trying to up the dosage after a few failed attempt. The key I took away from other comments is that I was likely missing the mark and not that it was too low of a dose.

Thanks everyone for the help!

Re: First Time Jitters

Posted: Sun Dec 09, 2018 8:56 pm
by bldoink
That's great that you're getting it sorted out successfully. Congratulations!