Just got a silicone seal for the mouth of the tube

Specific talk about pumps: Questions, hints, recommendations, etc.

Moderator: Larry10625

Mustang64
Posts: 26
Joined: Wed Jun 21, 2017 8:52 am
Location: Orlando, FL

Just got a silicone seal for the mouth of the tube

Postby Mustang64 » Sun Sep 09, 2018 4:11 pm

I have a Pos T Vac system and had to work with my doctor to get one large enough to accommodate my girth.

This is actually my second unit. I went to my urologist for the first unit and they had a person doing demos and writing down information to be sent off to the pump company. The guy demo-ing it to me did not look at my anatomy but demoed on his shirt and fingers. I understood the process, but I was very unhappy with the pump that I received -- I completely filled the tube. Not bragging, just saying. Nevertheless I used it for a while on and off.

I went to the urologist again to schedule another procedure and as part of this was told that I'd receive a pump. "I already have one from you guys." The office then instructed me to bring my existing unit to my appointment.

Upon seeing my "old" pump, inside diameter about 2.25", my urologist immediately asked me how I'd ever been able to use it. "With a lot of lube." was my answer. He immediately went back to his store room and brought out one where the tube was about 3" in diameter. He said this was an appropriate size for me and made me show him that it would work for me and that I had sufficient room in the cylinder.

One thing I noticed right away was the squared off edge of the cylinder 'poked' my skin at the pubic area above my cock and the scrotum beneath. In talking with guys on here, I learned that you can get a "Silicone Pump Sleeve" that will not only help with the seal (I wax/shave so that's not really an issue) but also cushion the unforgiving edge of the tube as it pokes my tender flesh.

I just tried it out and all I have to say is the new combination of fat pipe and silicone cushion is WONDERFUL.

Don't give up! the right combination of hardware for your anatomy is possible!
Married 20+ years. Have had just about every urological procedure except penile prosthesis. Castrated but on Test Cyp 200mg/week and Arimidex 2mg/week. Usually naked but kilted if not. Ask me anything.

Floridian
Posts: 287
Joined: Mon Aug 22, 2011 5:20 pm

Re: Just got a silicone seal for the mouth of the tube

Postby Floridian » Fri Sep 14, 2018 9:14 pm

I totally agree with you cause that sleeve works wonders. your balls can't be sucked in too.

Good luck
Titan implanted by Dr Eid---- Due to the "wasting" from Peyronies, Implant was the only option for me.

oldbeek
Posts: 663
Joined: Sun Sep 10, 2017 1:46 pm
Location: Los Angeles area

Re: Just got a silicone seal for the mouth of the tube

Postby oldbeek » Mon Oct 22, 2018 1:08 am

I use a sleeve from calXotics from amazon. works on sleeve up to 3inch.
77, good health, RP 7-2017, all nerves taken , PSA 0.05, 4-18,, .08 11/18, Pain with trimix, implant 4-18, Infra-pubic, AMS lgx 15 cm with 5cm rte. Implant at USC Keck. Dr Boyd

alfa88
Posts: 78
Joined: Sat Jun 30, 2018 2:59 pm
Location: North of Gilligan's Island

Re: Just got a silicone seal for the mouth of the tube

Postby alfa88 » Mon Oct 22, 2018 2:07 pm

I'm confused. Do these sleeves work with the constriction rings? I've got an Encore manual, 2"od and pretty much everytime I pop the ring on I get a bubble/bulge and have to pull the ball sack skin back down then re-pump.
53 years old, married 32 years. Lifetime ED & PE. Tried Viagra W & W/O T-Shots, Levitra and Cialis, Edex with poor results. VED is a last resort.

AnotherOldMan
Posts: 131
Joined: Tue Dec 27, 2016 9:52 am

Re: Just got a silicone seal for the mouth of the tube

Postby AnotherOldMan » Tue Oct 23, 2018 1:49 pm

Do these sleeves work with the constriction rings?


Have you tried one of these?
http://uandmetime.com/products/store/#! ... ry=1213450
I barely feel the ring(s) go on and discomfort from the rings restriction is greatly reduced.
74 years old, married 50+ years, wife 75 years old
Started using VED about 2 or 3 years ago.

alfa88
Posts: 78
Joined: Sat Jun 30, 2018 2:59 pm
Location: North of Gilligan's Island

Re: Just got a silicone seal for the mouth of the tube

Postby alfa88 » Sat Oct 27, 2018 4:38 pm

Do these sleeves work with the constriction rings?



Have you tried one of these?
http://uandmetime.com/products/store/#! ... ry=1213450
I barely feel the ring(s) go on and discomfort from the rings restriction is greatly reduced.


I'm assuming the answer was yes. I ordered mine but jeez that's pricey(~$30+shipping) for a hunk of foam. After perusing the web for over an hour it seems u&metime is the only supplier that comes close. Now I'm off to wait by my mailbox. :D
53 years old, married 32 years. Lifetime ED & PE. Tried Viagra W & W/O T-Shots, Levitra and Cialis, Edex with poor results. VED is a last resort.

AnotherOldMan
Posts: 131
Joined: Tue Dec 27, 2016 9:52 am

Re: Just got a silicone seal for the mouth of the tube

Postby AnotherOldMan » Sat Oct 27, 2018 7:27 pm

$30+shipping) for a hunk of foam

Mine was $20 plus shipping came to almost $30.
$10 bucks less but still very pricey for a hunk of foam.
If it works for you it is well worth it. If not it is money flushed.

Be sure to soak in hot water then lube the sleeve b4 sliding on your limp dick.
Took some practice sessions for me to get the technique down, but I have always been awkward.

I pretty much use it every time we have sex. The only exception is when I use a Tantus C ring during sex. The C Ring and the foam sleeve are not compatible.
74 years old, married 50+ years, wife 75 years old
Started using VED about 2 or 3 years ago.


Return to “Pumps”

Who is online

Users browsing this forum: No registered users and 2 guests