FrankTalk.org

Hey guys, I just bought a new cock ring and am having a terrible time getting it on. In fact, I have not been able to get it on. Has anyone used this ring and if you have how did you manage to get it over your cock and balls? I have attached a photo.

I have one, or one extremely similar. It resides in my reject drawer. It must work well for some guys but I'm not one of them. I like the idea but separate rings work better for me.

I assume it is of gummy rubber.
Take the large hole, stretch it out using to hands. Put it around the base of cock and balls. At this time the remainder of the ring is pointing to the floor. Take the second hole and stretch it out as before. Put the balls through it. Gently release the stretch.
(And it took me multiple tries to put on a double t shaped ball separator strap. Pretty confusing.)

Keep in mind that the rubber may not slide over the skin without some kind of lubricant. Practice in the shower first.

Like mine, that one looks to be fairly firm silicone.

Guys, I will give limpbicuit's suggestion although I would do better in front of the mirror as I have a beer belly that blocks my view and I will use some lube. doink, yes is is of heavy silicon. The ad for it shows a guy stretching both holes a few inches wide but I just don't see how you can do it that way. I am going to give it a good try but I think I will probably end up using the one I have been, which just a "O" ring stretched and placed behind the cock base and balls. I will keep you posted.

Yeah after struggling with a couple of store bought ring contraptions, I tried a rubber band: presto! This is going to sound really silly, but the best ones for me are the thick, wide, strong, but not that big of diameter rubber bands that are always used to fasten a bunch of asparagus together in the produce sections . They tend to be blue or purple, easy to find in my night stand too! Since we really like asparagus I have a constant re-supply: most stores put two on each bunch. If you don't like asparagus, you'll just be wasting a couple of bucks to try this, and toss the veggie in trash on the way out of the store. I wash them with hand soap, I wouldn't want to get some kind of ick from the produce farms. My balls are kind of big (no bragging rights here, as my penis is barely average!) and I just couldn't make the purpose made ones work for me.

And my favorite is a 2 1/4 matte brass ring for horse harness that I bought for $0.75 at the local farm and ranch.
Must use these with care though. It would be really difficult to remove in case of "lockup". This would be a risky to use with injection therapy.
A properly sized neoprene or silicon ring from the plumbing department would give a similar effect without the risk. Searching through the horse halter repair section of a good farm and ranch store should produce some small straps about 3/8 to 5/8 inch wide with buckles. These are are very adjustable. If they are not small enough new holes can be added and the extra material can be cut off.
In my experience some of the pleasure of using these comes from the slight stretch they give to the skin around the dick and especially the ball sack.
Judging by what is available as manufactured cock rings makes me think that people have more imagination than knowledge about materials. Silicon rings that are too firm look downright painful.
And I'm chucking as I write this.... I'll bet that some people didn't know that grandpa was so far into kink.

The lower example looks almost doable.

I think this new ring is going to be retired. The ad has a photo of both holes being stretched very wide open, which would give plenty of room to put over your balls. Try as I might, I can not stretch either hole open enough to place over my balls. The upper hole can easily be placed around the cock base but the lower one just will not work, even with lube. Oh well, lesson learned.