Page 1 of 1

question on curving penis

Posted: Tue Oct 15, 2019 4:28 pm
by 82OVER
Am on trimix probably a low or moderate a 4 ? not savvy on the mix on the fourth refill and have been getting a curve to the right is this related to peyronies never had this before is this related to possibly sticking the same side have been sticking on the left side it is much easier for me , what should I do, have increased the injection amount for good results

Re: question on curving penis

Posted: Tue Oct 15, 2019 6:40 pm
by notaes
I have been using trimix for four years now. Prior to trimix never had any hard spots on my penis and never had any type of curve in my penis. My urologist never discussed any of this
Prior to prescribing trimix for me to use. If he had I don’t think I would have ever started using trimix. I have no doubt that using trimix has harmed my penis. I have hard spots (scarring) in both sides of my penis where I have injected trimix. My penis developed a curve in June of this year and my urologist( different from urologist that Started my trimix) acknowledged it was from scarring from using trimix. I have just about run out of ant place to inject trimix because of so much scarring on each side of my penis.

Re: question on curving penis

Posted: Tue Oct 15, 2019 6:49 pm
by tomas1
I really feel you should start injecting on the right side. If it straightens, start alternating sides and places up and down your guy.

Re: question on curving penis

Posted: Tue Oct 15, 2019 8:14 pm
by 82OVER
have recently started injecting on right much more difficult do you think it will straight up it also seems to getting shorter cant afford to loose any thanks guys

Re: question on curving penis

Posted: Tue Oct 15, 2019 11:48 pm
by Robert66
I too use same side i have lots a viens anyone using whole shaft and not just middle 1/3 ? I only inject about 6 times a month

Re: question on curving penis

Posted: Wed Oct 16, 2019 2:03 am
by Hunchback
I've been using monomix for ~15 years and have never had any problems with curvature or anything else. Obviously, trimix uses two more components, so it might be different.

At any rate you should follow the instructions and change side and application spot. Don't always inject at the same spot. After injecting, make sure you apply pressure on the spot for at least 30-45 seconds and then rub it to get the medication flowing.