Trimix gel

Anything goes when it comes to ED.
Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Re: Trimix gel

Postby Robert66 » Sun Feb 17, 2019 8:23 pm

BigEyes wrote:Roberts51

I see you found a source for Trimix Gel. Suggest you read my paragraph quoted below carefully before proceeding.

BigEyes wrote:Using Misoprostal, which comes in 200 mcg pills, I have found that 25-50mcg will produce a usable erection. Higher doses do not make the erection any better, it just lasts longer, often a couple hours. For me, much over 100 mcg causes some pain. So, this is where the critical item with the gel comes in. IF -- you were to inject a gel with a high concentration of PGE-1 (like their gel) deep enough into the uretha to reach the CC, using an eyedropper or some other means, it would likely cause priapism. This may require a trip to the ER and a needle aspiration of the penis. BigEyes







Catch 22. If you follow their method it dont work if you find a way to get.it in deeper.it works too well? So if you injected 20 units of PGE 1. which is diluted 10 to 1 that is ok but if you put the same 20 units of diluted PGE 1 into your urethra instead that could cause harm? That part is confusing seem same amount different methods of application. As to the pills yes easy to get here so if tou try 25mcg of solid pill mix with sterial water apply tat way works for you?
edex and tri mix 45/1/27 26 units

BigEyes
Posts: 103
Joined: Wed Jun 08, 2016 11:08 am
Location: Florida, USA
Contact:

Re: Trimix gel

Postby BigEyes » Mon Feb 18, 2019 11:06 am

The trimix gel comes in potent sizes up to a couple thousand mcg. So, if you stick a blob of that deep into your urethra, you will likely encounter serous problems.

20 mcg of PGE-1 via injection directly into the CC is typical with Trimix or Bimix prescription. The same 20 mcg going into the urethra must be absorbed into the CC thru the urethra. The efficiency is not the same. Injection is direct. Urethra is indirect.

When I used Trimix with 20 mcg of PGE-1 injected I would get an ache. But inserting PGE-1 into the urethra I use 25 to 50 mcg. Ache comes if I put in around 100 mcg of PGE-1.

Based on my reaction in my body, injecting PGE-1 is about 5x more efficient then depending on it to get absorbed in the urethra.
Doctor of Naturopathy (N.D.) and Herbalist. ED and occasional Anorgasmia from perineal surgery for rectal cancer Dec. 2012

Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Re: Trimix gel

Postby Robert66 » Mon Feb 18, 2019 7:01 pm

BigEyes wrote:The trimix gel comes in potent sizes up to a couple thousand mcg. So, if you stick a blob of that deep into your urethra, you will likely encounter serous problems.

20 mcg of PGE-1 via injection directly into the CC is typical with Trimix or Bimix prescription. The same 20 mcg going into the urethra must be absorbed into the CC thru the urethra. The efficiency is not the same. Injection is direct. Urethra is indirect.

When I used Trimix with 20 mcg of PGE-1 injected I would get an ache. But inserting PGE-1 into the urethra I use 25 to 50 mcg. Ache comes if I put in around 100 mcg of PGE-1.

Based on my reaction in my body, injecting PGE-1 is about 5x more efficient then depending on it to get absorbed in the urethra.





One last question them pills cost.about 5 dollars each here for 200 mcg. So tou split the pill into say 4 then crush up to 50 mcg add sterial water put into ureatha and in 10 min you could be ready ?
edex and tri mix 45/1/27 26 units

Robert66
Posts: 688
Joined: Thu Dec 28, 2017 10:39 pm

Re: Trimix gel

Postby Robert66 » Wed Feb 27, 2019 7:27 pm

Was hoping you would share the how to for us asia and europe members who cant get trimix
edex and tri mix 45/1/27 26 units

KeepItGoing
Posts: 3
Joined: Wed Jun 10, 2020 4:56 pm

Re: Trimix gel

Postby KeepItGoing » Tue Jul 14, 2020 11:59 am

Ok so looking on amazon for a reference dropper, any suggestions wirh a link on one that might work/be small enough?

Seems plastic way to go, but most are graduated before 2 in., but may not be searching correctly either.

KeepItGoing
Posts: 3
Joined: Wed Jun 10, 2020 4:56 pm

Re: Trimix gel

Postby KeepItGoing » Wed Sep 16, 2020 2:37 pm

KeepItGoing wrote:Ok so looking on amazon for a reference dropper, any suggestions wirh a link on one that might work/be small enough?

Seems plastic way to go, but most are graduated before 2 in., but may not be searching correctly either.



Ok so went ahead and gave it a go, found something similar to this at location craft store:https://www.amazon.com/Rienar-Disposable-Transfer-Graduated-Pipettes/dp/B00P7QZDK4/ref=mp_s_a_1_4?dchild=1&keywords=plastic+pipette&qid=1600281006&sr=8-4

One thing to note, where this kind of pippete plastic welds are can be pretty sharp relative to your tender parts, so I crafted on this welds with very sharp pocket knive to make a smooth uniform part on the ~1.5-2” tip part that goes in. The end tips are also not uniform so watch those and sand/adjust to smooth. Recommend lube, and patience on the use as other post mentions.

Curious if anyone has other style they like?

User avatar
flyingduck2019
Posts: 410
Joined: Tue Aug 06, 2019 3:15 pm
Location: Hemet, California

Re: Trimix gel

Postby flyingduck2019 » Mon Sep 21, 2020 4:08 pm

I would like to have someone who uses trimix jel PM me a photo of how it works and exactly how you apply it.
Phil, 75, married 54 years, ED started about 9 years ago. After viagra and cialis and pumping have found Trimix. Use 10 units injected with a partial erection. 31g-5/16" or 31g 1/2"needle. 10-1-30 :D :D :D Wife likes it too :D :D :D :D


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 22 guests