I was prescribed trimix of 30/3/50 and had 10 cc filled at a mail order compounding pharmacy in 2 ea. 5 cc vials. Since this was an upgraded mix for me, I had not found the optimum dose and went thru most of the first vial with a continual increase in dosage. For the second vial, I had settled on a ...

Added cock ring in 2016. After dosage reached 30 units, switch to quad mix in May 2018. Must you still use the ring? I also do but would like to get rid of it -- quite uncomfortable, but with ring can use Trimix of only 20 units (30/30/3). Went to 50 units and really still needed the ring. Thinking...

Called Talon and good news is they are considerably less expensive and charge the same for all (Trimix) mixes. Bad news is that they are not licensed for Alabama. Say it will be several months before available.

Interesting, I may try this. However it will only save a few cents. I think the pliers need to be sterilized as well.

No problem -- the pliers touch only the outer ring -- the inner cover remained on the vial.

Not to be considered as a recommendation, but just the way I did it. 1. Thoroughly clean the entire vial top with alcohol -- even dip it in alcohol. 2. With pliers remove the aluminum band around the seal. (Just crimping a small section should allow removal by hand.) 3. Lift the seal and draw soluti...

Sorry for deletion:

Do you leave the ring on throughout? I've gone to #31 x 5/16" and no bruise last 2 times. However, 12.5 units was initially rock solid, but today with 15 units, only 50% and had to add ring. Will go up 2.5 units next time.

yes use 31 ga needle. I Vac first to get large then inject with silicon cushion ring still on. Makes it large and you can see blood vessels that you want to miss. Do you leave the ring on throughout? I've gone to #31 x 5/16" and no bruise last 2 times. However, 12.5 units was initially rock so...

Re: OMG, use a thinner needle. I use 31G. I can't imagine sticking a 20G in my dick. Ouch! Using a thinner needle might cut down on bruising by itself.

My mistake -- should have stated 30 gauge.

First, a bunch of thanks for setting up this forum and for the many inputs and suggestions by the users. I just located the site and find the info very useful. Next, please advise if I violate any rules/protocol of the forum. Now an overview of my situation and experience. (I an in my 80's, have a n...