Hope eveything is ok

Sticking a needle Where? Courage, guidance and help.
sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Hope eveything is ok

Postby sliphill » Sat Mar 18, 2017 9:59 pm

Guys, I wanted to give my woman some satisfaction tonight, so I injected 100 units and put on an obson constriction ring (nubs and ears). I think it was the D one. Maximum hardness and only about only 3/4" diameter. Yeah, I got hard enough for penetration, and my girl came, but it was just too painful for me. Not enjoyable at all. I had to stop after about 5 or so minutes. It was hard getting it off. I noticed that I have a number of dark spots on my dick. Looks like what might be broken vessels. So did I make my leak even worse. Oh well, I can't take this ring shit, at least, not around the shaft. I think I might have made matters worse. My dick is hurting now. I ordered a stretchy ring from allknight.com that goes around cock and balls. I don't know, an implant is looking better and better.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm

rahod1
Posts: 397
Joined: Wed Jun 15, 2016 2:52 pm

Re: Hope eveything is ok

Postby rahod1 » Sun Mar 19, 2017 2:01 am

Ok you finally got HARD! Now try to pull back to 50 units using a less restrictive ring. Don't worry about local brusing/spots. Just indicates you went too far.

sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Hope eveything is ok

Postby sliphill » Sun Mar 19, 2017 7:59 am

rahod1 wrote:Ok you finally got HARD! Now try to pull back to 50 units using a less restrictive ring. Don't worry about local brusing/spots. Just indicates you went too far.



Ok, that's good to hear. I am waiting on a new ring allknight.com that goes around cock and balls. I will try a lesser dose with this ring.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm

sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Hope eveything is ok

Postby sliphill » Mon Mar 20, 2017 2:08 pm

Yeah, the bruising is already gone. I injected just way way too much. No need to do that much. Geeze, I did just 20 units today, and got hard without a ring. So Idk. I have been taking horse chestnut, maybe this is working.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm

JimStars
Posts: 844
Joined: Sun Jan 24, 2010 2:41 pm

Re: Hope eveything is ok

Postby JimStars » Mon Mar 20, 2017 3:03 pm

Slip,

Yes you be nutz going to 100 units. But just remember you do have some max units that will give you max hardness and anything above that amount will just make it stay same hardness but for a longer time (and maybe hurt more ). I cannot imagine using any Osbon ring after injection -- bound to be painful as you said -- especially with a pink D. I still say just use the velcro cable tie -- since you can easily adjust it up and down in tension.

Also on taking off Osbon rings you don't use the little ears to do that. They are only there to help slip a fingertip between the ring and the shaft .. one or two finger tip on each side .. and stretch the ring as best you can (sort of an oblong) to lift it off without it crushing your shaft all the way up. ... Be sure to file your fingernails down to nuthin so they do not cut the ring or your dick. This will work on even the tightest Osbons.

J
RP 2008 ... MUSE 2008-9 .. TriMix Gel 2009 .. Trimix 2009-2015 ... PGE-1 2016-2019 ..Misoprostal 2019 Onward. All worked.

sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Hope eveything is ok

Postby sliphill » Mon Mar 20, 2017 3:38 pm

JimStars wrote:Slip,

Yes you be nutz going to 100 units. But just remember you do have some max units that will give you max hardness and anything above that amount will just make it stay same hardness but for a longer time (and maybe hurt more ). I cannot imagine using any Osbon ring after injection -- bound to be painful as you said -- especially with a pink D. I still say just use the velcro cable tie -- since you can easily adjust it up and down in tension.

Also on taking off Osbon rings you don't use the little ears to do that. They are only there to help slip a fingertip between the ring and the shaft .. one or two finger tip on each side .. and stretch the ring as best you can (sort of an oblong) to lift it off without it crushing your shaft all the way up. ... Be sure to file your fingernails down to nuthin so they do not cut the ring or your dick. This will work on even the tightest Osbons.

J


OMG Jim, it was extremely painful. I slid it off, and it was not easy, but I did get the damned thing off. I tossed it out right away too. I was only able to get that obson ring on by sliding it over a piece of 1 1/2" PVC pipe and putting this over my dick after injecting. Got the idea from erectaid pumps. I thought, hey, this should stop the leak. Yeah, it might have, but it also led to some veins bursting. What in the world was I thinking.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm

rahod1
Posts: 397
Joined: Wed Jun 15, 2016 2:52 pm

Re: Hope eveything is ok

Postby rahod1 » Mon Mar 20, 2017 8:04 pm


sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Hope eveything is ok

Postby sliphill » Mon Mar 20, 2017 9:42 pm



Yes, I didn't like it. I found it hard to clasp. I'm looking forward to trying my new hardwear ring.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm

rahod1
Posts: 397
Joined: Wed Jun 15, 2016 2:52 pm

Re: Hope eveything is ok

Postby rahod1 » Tue Mar 21, 2017 1:30 am

I found it hard to clasp


Really? I find it quite easy...just line up the teeth with the notches and press it in.

sliphill
Posts: 1021
Joined: Mon Oct 29, 2012 8:27 am
Location: Charlotte, NC

Re: Hope eveything is ok

Postby sliphill » Tue Mar 21, 2017 8:49 am

rahod1 wrote:
I found it hard to clasp


Really? I find it quite easy...just line up the teeth with the notches and press it in.


I didn't feel like I could get it tight enough. Maybe I will give it another shot.
Ed (sliphill) 68

Implanted by Dr. Michael O'Neill in Charlotte, NC on 6/9/2017 with AMS 700LGX. 18 cm cylinders 3 cm RTE's.

Revision done by Dr. Maxim McKibbon in Charlotte, NC on 4/12/2023 with AMD 700 LGX 22 cm cylinders gm


Return to “Injections”

Who is online

Users browsing this forum: No registered users and 18 guests