Page 21 of 29

Re: Revision 2017

Posted: Sat Aug 05, 2017 11:04 pm
by alibaba
alibaba wrote:Note to self. I looked up and the maximum expandable size of this Titan cylinder is .86" or 22 mm. Literature says 21mm+ but then states 22mm. .75 is 3/4" .875 is 7/8" . Will do some dick measuring with pictures to see where things are now. Dr. Kramer seemed to think when we talked last that I had a lot of room for girth yet and I certainly used to. If it is like my AMS, it got fatter toward the glans over time, a long time. Till then it was a tapered cone.


Back on this subject. I did some measuring. I do not know if this tells me if I am maxed out on cylinder diameter yet or not. I know this is not scientific. It not only measures the cylinder but the skin and every dick related piece of body in between. Science has been dicked here. I must say this is by far an improvement over the Milam wreck which I place in the same standing as a coat hanger abortion. Poor man may have tried, who knows? He was too busy being arrogant. Bottom line, results MATTER and a bad outcome can be mostly fixed with a bit of work. Cheers.

Re: Revision 2017

Posted: Sun Aug 06, 2017 8:42 am
by Tybeeman
alibaba wrote:
alibaba wrote:Note to self. I looked up and the maximum expandable size of this Titan cylinder is .86" or 22 mm. Literature says 21mm+ but then states 22mm. .75 is 3/4" .875 is 7/8" . Will do some dick measuring with pictures to see where things are now. Dr. Kramer seemed to think when we talked last that I had a lot of room for girth yet and I certainly used to. If it is like my AMS, it got fatter toward the glans over time, a long time. Till then it was a tapered cone.


Back on this subject. I did some measuring. I do not know if this tells me if I am maxed out on cylinder diameter yet or not. I know this is not scientific. It not only measures the cylinder but the skin and every dick related piece of body in between. Science has been dicked here. I must say this is by far an improvement over the Milam wreck which I place in the same standing as a coat hanger abortion. Poor man may have tried, who knows? He was too busy being arrogant. Bottom line, results MATTER and a bad outcome can be mostly fixed with a bit of work. Cheers.


Ali, I am curious, I cant se the picture vey good you poste yesterday. What is your length?

Re: Revision 2017

Posted: Sun Aug 06, 2017 1:45 pm
by alibaba
7 inches now. Almost back to pre implant length.

Re: Revision 2017

Posted: Sun Aug 06, 2017 2:27 pm
by Nocturne
Really great news. Again, I don't need an implant yet, but I'm surely headed that way if I live long enough. It's good to see the light at the end of the tunnel. I'm happy for you, Ali.

Re: Revision 2017

Posted: Sun Aug 06, 2017 5:51 pm
by PFracture
alibaba wrote:7 inches now. Almost back to pre implant length.


Congratulations Ali! Loving to see you take measurements like that.. Haha always thought about telling people to try it and here you go! I just hope that guy who now has the implant with the 3 inches reads your whole thread and decides to take action!

Please keep us posted man.

Re: Revision 2017

Posted: Sun Aug 06, 2017 8:32 pm
by radiodec
When calculating widths, consider this. In one measurement direction the maximum cylinder width should be multiplied by 2 for the 2 cylinders wide by side. twice 22mm gives 44mm or 4.4 cm which converts to approximately 1.76 inches of width without any flesh at max expansion.

Just a bit of info for the discussion

David

Re: Revision 2017

Posted: Sun Aug 06, 2017 9:14 pm
by TANGERINE
Ali,
I am so very very happy for you that things seem to be settling down and that you are starting to be considered in the "successful" surgery group. I know that it has been a long road for you. You stayed strong, and you stuck with it, and now, finally, I hope you start to see the rewards ??

Re: Revision 2017

Posted: Sun Aug 06, 2017 10:12 pm
by alibaba
radiodec, thanks for the post. I've been so busy and coming in tired so many days lately that I really haven't really thought about it. Now who volunteers to squeeze their non implanted flaccid dick down in a C clamp :o and measure to see how much dick there is that we need to deduct off too find the cylinder size? :lol:

Re: Revision 2017

Posted: Tue Sep 12, 2017 9:50 pm
by alibaba
Update.
6 months, 11 days ,12 hours, 45 minutes.

No change in girth. Lately I have measured 6.25" length. Cannot get more than that.

The kinks in cylinders are a non issue any more. Actually I do not think there is any kinking or folds any more. Comfort is a non issue now working all day long.

Still the slightest noticeable curve to the left but again it is very very slight.

Flaccid it still does not hang center. Flops to the left with a bit of a roll.

I still like this Coloplast 100 times better than the AMS though I loved the AMS flaccid. Of course flaccid was not the purpose of the implant. Cheers.

Re: Revision 2017

Posted: Wed Sep 13, 2017 8:17 am
by Larry10625
maxxxxx wrote:
David_R wrote:I always wanted to buy a huge-sized condom in a drug store just to see the reaction of the cashier. ;)



" Please cashier, give me the super king condoms " ..

Of course, tell aloud :lol:



"Hey, are you sure this is the biggest one you got"??? "Oh sorry, I should lower my voice so I don't embarrass you"!!! :lol: :lol: :lol: :lol: :lol: